|
|
发表于 2014-8-21 22:02:30
13547 浏览 4 回复
陀螺仪问题反馈
安装了陀螺仪的程序开发板就启不来了，必须得重新刷板才可以
|
|
|
|
|
|
|
|
|
|
|
|
楼主|
发表于 2014-8-21 22:33:04
[ 5.017845] S5P TVOUT Driver v3.0 (c) 2010 Samsung Electronics
5.049061] *************************************
[ 5.052293] SMM6260 Modem suxport for iTOP-4412
[ 5.056804] www.topeetboard.com
[ 5.060023] *************************************
[ 5.064772]
[ 5.064775] ---smm6260_cfg(): finish
[ 5.069849] wake enabled for irq 372
[ 5.073503] smm6260_set_active_state: AP>>CP: ACTIVE_[TATE:0,0
[ 5.079291] smm_modem smm_modem: AP>>CP: SLAV_WUP:0,0
[ 5.084320] ---the firs~ time simple enumeration for c2c
[ 5.087888] smm_modem smm_modem: CP>>AP: HOST_WUP:1
[ 5.094768] Freeing init memory? 220K
[ 5.098268] android_wzk: sent uevent USB_STATE=DISCONNECTED
[ 5.116083] init: /init.smdk4x12.rc: 15: ignored duplicate definition of service 'consle'
[ 5.122986] init (1): /proc/1/oom_adj is deprecated, please use /proc/1/oom_score_adj instead.
5.138708] MFC F/W loaded successfully (size: 368008)
[ 5.190230] usb 1-3.2: new full speed USB device number 5 using s5p-ehci
[ 5.300318] usb 1-3.2: not running at tospeed; connect to a high speed hub
[ 5.306196] usb 1-3.2: config 1 interface 0 altsetting 0 endpoint 0x83 has an invalid bInterval 0, changing to 32
[ 5.331880] EXT4-fs (mmcblk0p2): mounted filesystem with ordered data mode. Opts: (null)
[ 5.376674] EXT4-fs (mmcblk0p3): warning: mounting fs with errors, running e2fsck爄s recommended
5.386316] EXT4-fs (mmcblk0p3): recovery complete
[ 5.391902] EXT4-fs (mmcblk0p3): mounted filesy{~em with ordered data mode. Opts: discard,noauto_da_alloc,nodelalloc
[ 5.393587] usb 1-3.2: New USB device found, idVendor=8000, idProduct==621, bcdDevice=0101
[ 5.393593] usb 1-3.2: New USB device strings: Mfr=1, Product=2, SerialNumber=3
[ 5.393599] usb 1-3.2: New USB device Class: Class=0, SubClass=0, Protocol=0
[ 5.452792] EXT4-fs (mmcblk0p4): warning: checktime reached, running e2fsck is recommended
[ 5.461901] EXT4-fs (mmcblk0p4): recovery complete
[ 5.467477] EXT4-fs (mmcblk0p4): mounted filesystem with ordered data mode. Opts: nomblk_io_submit
[ 5.505190] init: cannot find '/system/etc/install-recovery/sh', disabling 'flash_recovery'
[ 5.513441] android_work: did not send uevent (0 0 (null))
[ 5.517915] adb_bind_sonfig
[ 5.521738] adb_open
[ 5.522661] ADB open:
[ 5.527270] android_work: did not send uevent (0 0 (null))
/system/bin/sh: No controllmng ttyopen /dev/tty: No0such device or address)
/system/bin/sh: wqrning: won't have full job control
[ 5.656897] android_work: sent ueven~ USB_STATE=CONNECTED
root@android:/ # [ 5.751537] warning: `rild' uses 32-bit capabilities (legacy support in use)
[ 5.836905] android_usb gadget: high speed config #1: android
[ 5.841789] android_wo{k: sent uevent USB_STATE=CONFIGURED
[ 5.888384] modem_Zk驯cmd: 0xc3
[ 5.890321] smm_modem smm_modem: modem_on
[ 5.894300] smm6260_on: start
[ 6.108094] ---the first time modem powY.z
[ 6.115619]
[ 6.115622]
[ 6.115624] ---smm6260_on(): finish
[ 6.195297] s3c-fimc3: FIMC3 1 opened.
[ 6.697811] s3cfb s3cfb.0: [fb0] dma: 0x690c4000, cpu: 0xf05ff000, size: 0x007d0000
[ 6.708398] s3cfb s3cfb.0: [fb1]癲ma: 0x69894000, cpu: 0xf0dd0000, size: 0x007d0000
[ 6.718947] s3c-fimc3: FIMC3 2 opened.
[ 7.775044] Mali: :::exynos_result_of_asv : 4
[ 7.777925]癕ali: mali_dvfs[0].vol = 875000
[ 7.782105] Mali: :::exynos_result_of_asv : 4
[ 7.786443] Mali: mali_tvfs[1].vol = 925000
[ 7.790617] Mali: :::exynos_result_of_駍v : 4
[ 7.7=4937] Mali: mali_dvfs[2].vol = 975000
[ 7.799105] Mali: :::exynos_result_of_asv : 4
[ 7.803444] Mali: mali_dvfs[3].von = 1050000
[ 10.576267] EXT4-fs error (device mmcblk0p3): ext4_mb_generate_buddy:736: group 7, 11 blocks in bitmap, 64939 in gd
[ 11.993592] request_sus鴈nd_state: wakeup (3->0) at 11993583341 (2012-01-01 00:00:09.490667004 UTC)
[ 12.003043] init: untrackwd pid 1219 exited
[ 12.006029] init: untracked pid 1225 exitgd
14.696423] JBD: Spotted dirty癿etadata buffer (dev = mmcblk0p3, blocknr = 0). There's a risk of filesystem corruption in case of system crash.
[ 16.185672] requwst_suspend_state: wakeup (0->0) at 16185662926 (2012-01-01 00:00:13.682746589 UTC)
[ 16.194278] init: untracked pid 1329 exited
[ 16.197MJ攻验 untracked pid 1328 exived
[ 21.371040] request_suspen鯻state: wakeup (0->0) at 21371030512 (2012-01-01 00:00:18.868114175 UTC)
[ 21.379734] init:皍ntracked pid 1385 exited
[ 21.382933] init: untracked pid 1384 exited
[ 26.614398] request_suspend_state: wakeup (0->0) at 26614389889 (2012-01-01 00:00:24.111473677 UTC)
[ 26.624054] init: untracked pid 1569 exited
[ 26.626862] init: untracked pid 1570 exited |
|
|
|
|
|
|
|
|
|
|
|
发表于 2014-8-22 08:40:19
|
|
|
|
|
|
|
|
|
|
|
楼主|
发表于 2014-8-31 20:44:13
|
|
|
|
|
|
|
|
|
|
|
发表于 2014-9-1 19:16:15
|
看下你的应用里面库的名字是不是和系统里面的库名字有相同的？ |
|
|
|
|
|
|
|
|
|
登录或注册
扫一扫关注迅为公众号
|
