imx6q烧写官方ubunut镜像mfg卡在jumping to OS image

蓝翎昱

烧写官方镜像时卡在jumping to OS image不动了内核烧不进去是什么原因用1.21Mfgtools-Rel-1.1.0_180706_MX6Q_UPDATER这个工具uboot烧进去了
串口打印：
U-Boot 2009.08-dirty (Jun 27 2018 - 15:27:41)

CPU: Freescale i.MX6 family TO1.5 at 792 MHz
Thermal sensor with ratio = 181
Temperature:   28 C, calibration data 0x57a4e469
mx6q pll1: 792MHz
mx6q pll2: 528MHz
mx6q pll3: 480MHz
mx6q pll8: 50MHz
ipg clock     : 66000000Hz
ipg per clock : 66000000Hz
uart clock    : 80000000Hz
cspi clock    : 60000000Hz
ahb clock     : 132000000Hz
axi clock   : 264000000Hz
emi_slow clock: 132000000Hz
ddr clock     : 528000000Hz
usdhc1 clock  : 198000000Hz
usdhc2 clock  : 198000000Hz
usdhc3 clock  : 198000000Hz
usdhc4 clock  : 198000000Hz
nfc clock     : 24000000Hz
Board: i.MX6Q-SABRESD: unknown-board Board: 0x63015 [WDOG ]
Boot Device: SD
I2C:   ready
DRAM:   1 GB
MMC:   FSL_USDHC: 0,FSL_USDHC: 1,FSL_USDHC: 2,FSL_USDHC: 3
Using default environment

In:    serial
Out:   serial
Err:   serial
Net:   FEC0 [PRIME]
Erase EMMC start Blocks(0-200)
mmc3(part 0) is current device
Device 3: boot partition 1 is for boot
Device 3: boot partition 1 is for boot
Hit any key to stop autoboot:  0
## Booting kernel from Legacy Image at 10800000 ...
   Image Name:   Linux-3.0.35-g7c686b7-dirty
   Image Type:   ARM Linux Kernel Image (uncompressed)
   Data Size:    3965568 Bytes =  3.8 MB
   Load Address: 10008000
   Entry Point:  10008000
   Verifying Checksum ... Bad Data CRC
ERROR: can't get kernel image!
MX6Q SABRESD-MFG U-Boot >



配置文件

[profiles]
chip = MX6Q Linux Update

[platform]
board = SabreSD

[LIST]
name =Ubuntu-SabreSD-eMMC

admin

官方镜像指的是飞思卡尔官方的镜像吧？
在我们的板子上，烧写迅为的镜像有问题么